How to change a visor on a MOMO FGTR Evo Helmet

We’ve been asked the question a few times so here are the instructions!

Take the plate in step two and line the two pins on the back with the two holes indicated in step 1 (see photos below).

Next is the indent plate, you will line up two smaller pins from the first plate and the two pins protruding from the indent plate will go through the holes in the visor as shown in step 4.

The last two pieces shown in step 5 hold the assembly together.

Now the trick here is to get the boss in the centre of the back of the large disk to centre with the hole in the visor.

Don’t worry about the slots as when you spin the “bolt” the twisting will eventually align the slots you just need to keep the visor and its stack all together and the centre boss aligned and as you get some tension on the bolt wiggle it a bit and it should all sit down nicely.

Good luck hope you have small fingers!

A big thanks for Chris for putting this together for us.